A handmade table decoration featuring an Atatürk silhouette. The sides and stand are 3D-printed from plastic. The center is cast from epoxy resin.
The product is illuminated. If you insert a CR2032 battery into the slot on the back, a yellow light will illuminate behind the silhouette. A single battery lasts for a maximum of 24 hours when continuously lit. However, I can say that the illumination in the dark is “perfect.”
I can create similar designs for you. Just contact me.
What’s included?
1 8cm diameter door ornament and stand
(1 CR2032 battery not included)
Production Story
This table ornament began its journey in a 3D modeling program. After revisions and final adjustments, it was printed. Then, for added durability, it was cast in epoxy.
